Rock Light Install - Plug&Play

ALL PLUG & PLAY ROCK LIGHTS INSTALLATION GUIDE
PRE INSTALL:
Before getting started, You’ll want to have a plan of where you will be installing each rock light.
STEP #1: Installing The Bluetooth Control Module

  • Keep the module tucked up on the inner side of the frame, below the cab, and away from engine heat. This will give the module a central location and reduce the need to extend the 15 foot wire leads. You may keep it in the engine bay as long as it is distanced from anything warm.
  • The module can alternatively be mounted to the battery or nearby without modification, in this instance, extensions will be needed!
  • You may use zip ties to secure the control box to the desired location.
  • We recommend wiring the control module to a switch to avoid the constant flow of power through the module(relay is suggested)
  • Red - Power / Positive(or switch)
  • Black - Ground
  • White wire - solid “no modes” override(to power)
  • Blue wire(Rgbw) - Brake Lights
  • Green / Yellow - Positive Signal Wore

STEP #2: Installing The Rock Lights
In Your Wheel Well

  • You’ll want to remove the plastic liners if you have them.
  • Place your rock light in the desired location and pre-drill holes that align with the rock light mounting locations.
  • Drill a third wider hole for the wire lead to fit through.
  • Use provided mounting hardware to secure the rock light & feed the wire lead through the third hole.

Underbody & Misc

  • If you have purchased our magnetic mounts, your install just got a whole lot easier!
  • Simply install our magnetic mounts on the pods and place them in your desired location! If you don’t have our magnetic mounts you may need to use self tapping screws and or adhesive to mount the pods, however we suggest against this.

STEP #3: Securing The Wire leads

  • Wheel Light extensions(18AWG) can be used to relocate splitters to divide the extra wire into multiple locations and remove the need for extensions on multiple lights
  • Run the wire leads along the vehicles existing wiring keeping them tucked away and as high as possible. Using zip ties, secure the wires tightly so they cannot be easily pulled out of place.
  • Plug the wire lead into the corresponding Control Module hookup, ensuring your female and male end arrows are aligned.

STEP #4: Bluetooth Remote/App

  • We highly recommended connecting the app first via bluetooth (LEDSHOW).
  • Download the app from your app store and make sure your phone's bluetooth is on without any paired devices.
  • Make sure your control module is efficiently supplied with a 12v power source and the fuse is in proper condition.
  • Your device will automatically pair to the module, and then you can control everything.